One question we get asked about the Powerlet Wireless Temperature Controllers , is how to synch the controller to the receiver when the unit is new or when the batteries are replaced.
The process is pretty straightforward and we’ve listed the process step by step below.
Once the batteries are installed, and with the receiver unplugged from the power supply, simply perform the following steps and you’ll be ready to use your new wireless controller.
Turn the red knob on and then off quickly 3 times (6 clicks) until the LED’s on the remote start double blinking
You then have 10 seconds to plug the receiver in to the power supply on the bike.
- Make sure that when you plug the receiver in that the power supply is active.
- On switched ports this usually just means having your ignition turned to the “On” position. If you don’t have power to the plug, the receiver will not synch up.
- That’s it, you’re done!
The controller is now paired with the receiver and you should not have to perform this procedure again.